Product Manual

Power Unit Column

Adjust the slack in the single point lock cable at the power unit side so that when the

release lever is pulled down both carriage locks will disengage. Tighten the cable

clamps and install the carriage lock covers on each side with the four (4) provided

screws. (Factory tip: Adjust the cables to release the locks just before the lock

release lever has reached maximum travel…this prevents overstretching the cable).

At this time install the carriage lock covers and install the release lever on the power

unit column.

INSTALLING THE LIFT ARM ASSEMBLES

All four (4) arms come completely assembled. The long 2-piece arms are mounted

to the rear of the lift and the shorter 3-piece arms are mounted to the front of the lift.

Insert the arm assembles in the correct gaps in the carriage. Align the holes in the

carriage with the holes in the carriage and insert the metal arm pivot pins. Repeat

for all arms. When the arms pivot pins have been installed use the provided metal

retaining rings and attach them to the grooves in the bottom edge of the arm pivot

pins to prevent these pivot pins from moving upward. See photo below for

reference.