Product Manual

37
FINAL CHECK OF ASSEMBLED LIFT
OPERATING INSTRUCTIONS
Read and understand all safety and operation labels on the lift. Refer to the
"Lifting it Right"
manual and
"Safety Tips"
card supplied to you for additional
important instructions and information.
NOTE:
Some vehicles may have the manufacturer's Service Garage Lift Point
locations identified by triangle shape marks on its undercarriage (reference SAE
J2184). Also, there may be a label located on the right front door lock face
showing specific vehicle lift points. If the specific vehicle lift points are not
identified, refer to the "Typical Lift Points" figure below or the ANSI/ALI
Lift Point
Guide
included with your lift.
1. Final dimension check after anchoring
2. Check for hydraulic leaks.
3. Ensure cables are properly routed and free from
obstructions.
4. Check jam nuts on cables are tightened.
5. Check for oil leaks.
6. Check adjustment of safety release cable to ensure both
sides are working properly.
7. Re-check level of towers.
8. Check torque of anchor bolts.
9. Check all fasteners, tighten if necessary.
10. Check shut off at top of stroke to ensure lift shuts off.
11. Check proper operation of arm restraints.
12. Operate lift to full stroke then lower to ground while checking
for proper functionality.
13. Check proper operation of arm restraints.
14. Ensure all documents listed below are given to the owner.
15. Operation Manual
16. ANSI / ALI Lift It Right Manual
17. ANSI / ALI Safety Tip Card
18. ANSI / ALI ALIS Safety Requirements for Installation
19. ANSI / ALI Quick Reference Guide
20. Train end user on operation of lift.