Use and Care Manual

1. Thread two headless screws through the mounting plate, then secure them with four lock nuts(two
on each side of the mounting plate). Adjust the length of the headless screws if necessary.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with
two bolt nuts.
5. Attach the bobeches and candle tubes onto the sockets, then install bulbs (not included). See
relamping label at socket area or packaging for maximum allowed wattage.
6. Turn on the power at the main fuse or circuit breaker box.
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
Mounting Screw
Fixture Wire
Lock Nut
Mounting Plate
House Grounding Wire
Green Grounding Screw
Wire Nut
Headless Screw
Outlet Box
Back Plate
Bolt Nut
Candle Tube
Bobeche
Socket
Assembly Instructions
Madley Wall Light # WMY111
Bulb Type B Max.60W
(not included)
Fixture Grounding Wire