Instructions / Assembly

Assembly Instructions: DDDD-BA1
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromthewall,includingtheold
mountingstrap.
Mountingstrap(A)maybeattachedtobackplate(D).The
mountingstrapcontainsseveralpairsofthreadedholes.Find
thepairofholesthatmatchesthespacingoftheholesonthe
junctionboxandyourxturebackplate.Besurethatthescrew
holesarevertical.Pullthehousewiresthroughthecenterof
mountingstrap(A).Placemountingstrap(A)overthejunction
boxsothatmountingscrews(B)maybeinsertedhorizontally
andalignthescrewholelocationsonthemountingstrapwith
theholelocationsonxturebackplate(D).Securemounting
strap(A)tothejunctionboxwithmountingscrews(B)anda
screwdriver.Tightenthescrewssecurely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whitetowhite
(orribbed);groundtoground(greenorcopper).Twisttheends
ofthewirepairstogether,thentwistonawireconnector.Make
surealltwistsareinthesamedirection.Ifthereisnogroundwire
(greenorcopper)fromthejunctionbox,locategroundscrew(C)
onmountingstrap(A)andwrapthexturegroundwirearound
thegreengroundscrew(C).Useascrewdrivertosecureground
screw(C)ontothemountingbracket.Tuckallwiresneatlyinto
thejunctionbox.
FINISHING THE INSTALLATION
Placexturebackplate(D)overmountingstrap(A)sothatthe
holesinthetopofthemountingstraplineupwiththeholes
inthebackplate.Threadscrews(E)intobackplate(D)until
backplate(D)issnugagainstthewall.
Slideglassshade(G)oversocket(F)andsecureinplacewith
spacer(H)followedbysocketring(I).
Installthebulb(notincluded)inaccordancewiththexture’s
specications.Donotexceedtherecommendedwattage.
Your installation is now complete. Turn on the power and test the
xture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
Toll Free: 800.277.0979 Ext. 0 or
Email: [e-mail]
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)