Installation Guide

LMW - Colony Collection Owner’s Manual
If your bath has a whirlpool system, simply pushing the push-button located on the tub will turn the tub on or
off. The button next to it will cycle through the various speeds of the pump (low, medium, and high).
Individual jets may be adjusted by turning the jet ring/trim clockwise and the water flow will increase, while
turning the jet trim counterclockwise will decrease the water flow. The jets can be closed if turned far enough
counterclockwise. The 8 jet system has a 2 hp pump and requires a 20 amp dedicated circuit, 120V.
The air bath is operated by touching the control pad pictured below.
1 2 3 4
1. ON/OFF – Press to start, press again to stop
2. INCREASE SPEED – Press and hold to increase the speed of air flow. Release when desired speed is reached.
3. DECREASE SPEED – Press and hold to decrease the speed of air flow. Release when desired speed is
reached.
4. PULSE CYCLES – Pressing this button once will turn on Wave Mode which fluctuates the blower from
minimum to maximum power. Pressing the button again changes to Pulse Mode. In Pulse Mode, the blower
will release air in short, intense bursts. Pressing the button again will return the blower to normal.
Standard Drying Cycle – An automatic drying cycle will start 20 minutes after the blower is turned off. The
blower LED blinks while waiting for the purge cycle.
24 Hour Programmable Drying Cycle – The system must be stopped prior to activation or deactivation.
Activation – Determine at which time you wish the purge to activate. At that precise time press and hold
Button 2 on the keypad for 5 seconds. All of the LED lights will flash twice to confirm the activation is
complete. The purge cycle will now start at the programmed time every 24 hrs. In the event of a power
failure the program will be automatically deactivated.
Deactivion – Press and hold Button 2 for 5 seconds. All of the buttons will flash once to confirm deactivation.
Functioning
1) 16 lateral turbo air injectors spaced around the lower side walls of the tub.
2) The system functions with a 2 hp blower / 600W air heater that is separate from any other systems.
3) This system requires a 20Amp dedicated circuit, 120V.
4) The air heater is designed to provide a warm air massage. It is not designed to heat the bath water.