Installation Guide

LMW - Colony Collection Owner’s Manual
Whirlpool Inline Heater
The inline heater is designed to MAINTAIN the temperature
of the bath water between 101-104 degrees Fahrenheit. These
limits cannot be increased or decreased. The Heater is operated by a
pressure switch which is programmed into the heater. This switch allows the
heater to operate only when there is sufficient water flowing through the system.
DO NOT BYPASS THE SWITCH. This option is equipped with a molded plug on the
end of a supply cord. Check your local codes and install a 120VAC 20amp GFCI protected dedicated circuit wall
outlet within 1.5’ from the heater unit. Plug the cord into the outlet. Every time the whirlpool unit is
activated, the heater will activate as well, and will MAINTAIN the water’s temperature between 101-104 F.
Water Heater for Air Bath and Soaker Tubs
The on/off button on the bath tub activates/deactivates the heater. The heater has a built-in 20 minute timer
and is a low flow/high efficiency pump, providing silent operation. The option is equipped with a molded plug
on the end of a power supply cord. Check your local codes. For the LM305 install a 120 VAC 15amp GFCI, and
for the LM306, install a 250 VAC 25amp GFCI. Both water heaters should have a GFCI protected dedicated
circuit wall outlet located within 1.5’ from the heater unit. Plug the cord into the outlet. This heater is
designed to MAINTAIN the temperature in your bath water between 101-104 deg Fahrenheit. These
temperatures are preset and cannot be adjusted.
Hydrotherapy Back Massage System & Neck Massage Pillow Neck Massage Pillow Control
Back Massage Functioning - Includes 8 jets that function on an independent 3/4 hp (7.5Amps). 2 jets work at
a time cycling up and down your back. This system requires a 20Amp dedicated circuit, 120V.
Back Massage Controls – DO NOT OPERATE the back massage system before you are in the tub and ready
for use. Doing so will spray water out of your tub! (1) The push button located at the bottom left of the
photo above turns the unit on and off. The dial (2) on the left is the Air Control for the back massage system.
Adjusting this will increase and decrease the intensity of the jets. The large dial (3) on the right will adjust the
cycling speed of the jets from completely stopped on 2 active jets, to quickly cycling up and down through the
entire back massage system.
Neck Massage Controls – DO NOT OPERATE the neck massage before you are in the tub and ready for use.
Doing so will spray water out of your tub! The middle button (4) is the On/Off button. Pushing the button on
the left will adjust the speed of the neck massage jets and set them to pulse simultaneously. Press once for
fast, twice for medium, and three times for low speed. The button on the right performs the same function,
only with the jets alternating back and forth. Once activated, the neck massage will run on a 20 min timer.