Operating Guide

LMW - Colony Collection Owner’s Manual
Chromotherapy Mood Light
The ColorGlo LED Multi-Color bath light comes pre-programmed with 10 light modes. To change modes,
switch the unit off and then back on within 5 seconds. To resume a lighting mode, leave the unit switched off
to save the last lighting mode displayed in memory. That same lighting mode will display the next time the
unit is switched on. DO NOT attempt to service the electronic components yourself. Any opening, altering or
tampering with this product will void the manufacturer’s warranty. DO NOT submerge the transformer in
water or allow it to get wet. Keep the unit dry at all times. DO NOT allow this unit to freeze.
Ozonator
This factory installed option sanitizes your whirlpool. When your whirlpool system is operating your ozonator
is generating ozone which is mixed with the re-circulating bath water. The ozone helps neutralize soaps, body
oils and other organic and inorganic materials. This unit eliminates the need to run a sanitation solution
through the tub’s circulating system.
Aromatherapy
This option uses your favorite pure essential oils and their fragrances to treat your mind and body. A few
drops added to a felt pad in the aromatherapy canister provides the scent to relax and achieve your desired
mood. Place the cap on the canister and operate your air massage system. The scent is drawn into the air
system and blown through the air injectors.
Solo Touch Control
The Solo Touch system operation and installation information is shown below.
Features:
Pulsating Mode- The pump speed varies automatically with a cycle period of approximately 10 seconds. Speed
10 is the default speed but the keypad will remember the last speed used after being shut down and will
automatically revert to that speed. *Wait 5 seconds after powering on the unit to adjust the speed settings*