Installation Guide

LMW - Colony Collection Owner’s Manual
Chromotherapy Mood Light
The ColorGlo LED Multi-Color bath light comes pre-programmed with 10 light modes. To change modes,
switch the unit off and then back on within 5 seconds. To resume a lighting mode, leave the unit switched off
to save the last lighting mode displayed in memory. That same lighting mode will display the next time the
unit is switched on. DO NOT attempt to service the electronic components yourself. Any opening, altering or
tampering with this product will void the manufacturer’s warranty. DO NOT submerge the transformer in
water or allow it to get wet. Keep the unit dry at all times. DO NOT allow this unit to freeze.
Ozonator
This factory installed option sanitizes your whirlpool. When your whirlpool system is operating your ozonator
is generating ozone which is mixed with the re-circulating bath water. The ozone helps neutralize soaps, body
oils and other organic and inorganic materials. This unit eliminates the need to run a sanitation solution
through the tub’s circulating system.
Aromatherapy
This option uses your favorite pure essential oils and their fragrances to treat your mind and body. A few
drops added to a felt pad in the aromatherapy canister provides the scent to relax and achieve your desired
mood. Place the cap on the canister and operate your whirlpool or air massage system. The scent is drawn
into the air system and blown through the whirlpool jets and/or air injectors.
Solo Touch Control
The Solo Touch system is operated by the control pad shown below
Features:
Pulsating Mode- The pump speed
varies automatically with a cycle
period of approximately 10
seconds. Speed 10 is the
default speed but the keypad
will remember the last speed used
after being shut down and will
automatically revert to that speed.
*Wait 5 seconds after powering on the unit to adjust the speed settings.
Understanding the Unit
1
2
3
4
5
6
7
8
9
Display
Temperature in F
Speed level
Time remaining
Power button
Speed + button
Speed - button
Pulse mode button
Light button
Screen off/on – Displays temperature, speed, time remaining, or error info.
When on, displays temperature value in degrees Fahrenheit.
When on, displays speed level from 1 to 10
When on, displays the time remaining in minutes
1
st
press activates pump, light, and LED, 2
nd
press deactivates pump light & LED.
Speed increases by 1 level, display will show current speed.
Speed decreases 1 level, display will show current speed.
1
st
press activates pulse mode & LED, 2
nd
press deactivates pulse mode & LED
1
st
press activate Light mode & LED, 2
nd
press deactivates light mode & LED