Installation Guide

Laurel Mountain - Owner’s Manual
If your bath has a whirlpool system, simply pushing the on/off button located on the tub will turn the tub on
or off. The button next to it will cycle through the various speeds of the pump (low, medium, and high). Jets
may be adjusted by turning the jet ring/trim counterclockwise and the water flow will increase, while turning
the jet trim clockwise will decrease the water flow. The jets can be closed if turned far enough clockwise. The
whirlpool system requires a 20 amp dedicated circuit, 120V.
The air bath is operated by one of the control pads pictured below.
1. ON/OFF – Press to start, press again to stop
2. PULSE CYCLES – Pressing this button once will turn on Wave Mode which fluctuates the blower from
minimum to maximum power. Pressing the button again changes to Pulse Mode. In Pulse Mode, the blower
will release air in short, intense bursts. Pressing the button again will return the blower to normal.
3. INCREASE SPEED – Press and hold to increase the speed of air flow. Release when desired speed is reached.
4. DECREASE SPEED – Press and hold to decrease the speed of air flow. Release when desired speed is
reached.
Standard Drying Cycle – An automatic drying cycle will start 20 minutes after the blower is turned off. The
blower LED blinks while waiting for the purge cycle. For a manual cycle, hold the #1 button for three seconds
for an immediate purge.
Functioning
1) Lateral turbo air ports spaced around the lower side walls of the tub.
2) The system functions with a 2 hp blower / 300W air heater that is separate from any other systems.
3) This system requires a 20Amp dedicated circuit, 120V.
4) The air heater is designed to provide a warm air massage. It is not designed to heat the bath water.