Installation Guide

ManualsBrandsLaurel Mountain ManualsBathroomParker 21 32-in W x 60-in L White Acrylic Rectangular Right-Hand Drain Alcove Air Bath

Contents Page Contents Page

Specifications 1 & 2 Care & Cleaning 4

Rough In Instructions 2 Whirlpool Operation 5

Electrical / Wiring 3 Air Bath Operation 5

Plumbing Instructions 3 Extra Options / Features / Warranty 6 & 7

Operating Instructions 4 Troubleshooting 8

LAUREL MOUNTAIN – OWNER’S MANUAL

For your installation, operation, and maintenance needs.

Whirlpools Air Baths Combo Baths Soakers

About this Owner’s Manual

Laurel Mountain has gained popularity by the variety of bathtubs available and the extensive list of options for

each type of tub. This manual covers the installation, operation, and maintenance needs for whirlpools, air

baths, combo baths, and soaker tubs. If you have any questions or need additional information on your Laurel

Mountain bath, you can contact our customer service department Mon-Fri at 1-800-930-0050 between 6:00

am and 6:00 pm EST.

*INSTALLATION WARNING*

*Your Laurel Mountain bathtub has been water tested prior to shipment. However, due to transportation

and potential on-the-job conditions, you should NOT install this tub until performing a water test. A second

water test should also be performed once the tub is in its final location prior to completing the install. The

water test should include operation of any and all systems, jets, controls, etc.

*Building material & wiring should be routed away from the pump or other heat producing parts of this tub.

*Please follow these instructions to ensure an easy and safe installation process. Unless written approval is

obtained from Laurel Mountain, any deviations, additions, or deletions to your tub or its hardware will void

the warranty.

Your Laurel Mountain tub was created to your order specifications. The tub was constructed from a cast

acrylic shell. It was then reinforced with a mixture of chopped fiberglass in a polyester resin applied to the

backside of the shell. The base of your unit was designed to give uniform support to the tub floor and has

been pre-leveled. It meets or exceeds load-bearing and impact resistance requirements of the listed standard

without evidence of crazing or cracking and with minimal deflection when installed in accordance to Laurel

Mountain printed instructions.

PRIOR TO INSTALLATION

Immediately inspect your tub for any cosmetic defects or damage. If any problems or concerns are discovered,

contact Laurel Mountain on how to proceed. DO NOT remove the bath from its shipping container until you

are ready to water-test and install. When you are prepared to remove the tub from its carton DO NOT LIFT the

tub out by its plumbing. We also recommend cutting cardboard from the shipping container to place inside

the tub to protect its floor. Even though your tub has been inspected and water tested prior to

shipment, it is very important that you perform a water test of your own to ensure all of the

SB1.20

Summary of content (10 pages)

PAGE 1
LAUREL MOUNTAIN – OWNER’S MANUAL For your installation, operation, and maintenance needs.
PAGE 2
Laurel Mountain - Owner’s Manual fittings and connections were not damaged during transit. Take your tub to an area where you can fill it up, run electrical components, and drain it. Fill your tub to the overflow and if you have a pump and/or blower, operate it and all components (chromatherapy, ozonator, back massage, neck massage, and heater) for 15 minutes. Inspect the entire unit during and after for leaks. Any defects that are discovered MUST be reported at this time to qualify for warranty coverage.
PAGE 3
Laurel Mountain - Owner’s Manual Rough in the wiring on a single 120VAC, 20 amp, GFCI protected dedicated circuit for each whirlpool, air system, or heater installed on the tub. WARNINGS: 1) All electrical connections must be made by a licensed certified electrician in accordance with the requirements of the National Electrical Code and applicable state and local codes and procedures. 2) All circuits connected to this unit must be equipped with Ground Fault Circuit Interrupter (GFCI) protection.
PAGE 4
Laurel Mountain - Owner’s Manual Laurel Mountain will not be held responsible for water damage of any kind in connection with the installation and/or operation of one of our bathtubs. All whirlpool jets must be completely submerged below water before starting the pump. Do not operate the pump without water as damage may occur. Do not block the overflow drain and allow water to reach the controls as they are not waterproof and leaks to the floor may occur.
PAGE 5
Laurel Mountain - Owner’s Manual If your bath has a whirlpool system, simply pushing the on/off button located on the tub will turn the tub on or off. The button next to it will cycle through the various speeds of the pump (low, medium, and high). Jets may be adjusted by turning the jet ring/trim counterclockwise and the water flow will increase, while turning the jet trim clockwise will decrease the water flow. The jets can be closed if turned far enough clockwise.
PAGE 6
Laurel Mountain - Owner’s Manual Whirlpool Inline Heater The inline heater is designed to MAINTAIN the temperature of the bath water between 101-104 degrees Fahrenheit. These limits cannot be increased or decreased. The Heater is operated by a pressure switch which is programmed into the heater. This switch allows the heater to operate only when there is sufficient water flowing through the system. This option is equipped with a molded plug on the end of a supply cord.
PAGE 7
Laurel Mountain - Owner’s Manual Silent Pump Upgrade The Silent pump has a simple, push-button operation. It does not include a 3-speed control like the standard pump. However, all the whirlpool jets can be individually adjusted for intensity. With it’s revolutionary design, the heat energy generated by the pump is released into the water.
PAGE 8
Laurel Mountain - Owner’s Manual Music. Lights. Vibe To Connect to Bluethooth, press the On/Off button on the Keypad, then go to the Bluetooth settings in your smart device to locate “Vibe” and connect to it. To sync to the music & lights, start the music, then activate the lights. The first 3 lights settings below can be synced with music.
PAGE 9
Laurel Mountain - Owner’s Manual Chromotherapy Mood Light The Chromotherapy mood light is activated & deactivated by a single press of the button. It also comes preprogrammed with 12 light modes. To change modes, quickly double press the button.
PAGE 10
Laurel Mountain - Owner’s Manual Troubleshooting Common Issues WHIRLPOOL PROBLEM ON/OFF BUTTON Won’t depress PUMP -Won’t Start SOLUTION AIR BATH PROBLEM Remove trim ring and plunger. Clean interior, lubricate with small amount of vasoline. BLOWER -Fails to operate - Turns on by itself -Motor hums -Runs but no air blown through jets LEAKS -Pump Unions -Pump o-ring or seal -Pipe to Jet Loosen pump unions and inspect o-ring for proper sealing. Retighten.