Installation Guide

ManualsBrandsLaurel Mountain ManualsWhirlpool Tub & Air Bath PartsLM335

Contents Page Contents Page

Specifications 1 & 2 Care & Cleaning 4

Rough In Instructions 2 Whirlpool Operation 5

Electrical / Wiring 3 Air Bath Operation 5

Plumbing Instructions 3 Extra Options / Features 6 & 7

Operating Instructions 4 Warranty & Troubleshooting 8

LAUREL MOUNTAIN – OWNER’S MANUAL

For your installation, operation, and maintenance needs for all Colony units.

Whirlpools Air Baths Combo Baths Soakers

About this Owner’s Manual

Laurel Mountain Whirlpools has gained popularity by the variety of bathtubs available and the extensive list of

options for each type of tub. This manual covers the installation, operation, and maintenance needs for all of

the Colony Series Laurel Mountain whirlpools, air baths, combo baths, and soaker tubs. If you have any

questions or need additional information on your Laurel Mountain Whirlpools bath, you can contact our

customer service department Mon-Fri at 1-800-930-0050 between 6:00 am and 6:00 pm EST.

*INSTALLATION WARNING*

*Your Laurel Mountain Whirlpools bathtub has been water tested prior to shipment. However, due to

transportation and potential on-the-job conditions, you should NOT install this tub until making a final

water test.

*Building material & wiring should be routed away from the pump or other heat producing parts of this tub.

*Please follow these instructions to insure an easy and safe installation process. Any deviations, additions,

or deletions to your Laurel Mountain Whirlpools tub or it’s hardware will void the warranty of this product

if written approval is not obtained from the manufacturer.*

Your Laurel Mountain Whirlpools unit was created to your order specifications. The tub was constructed from

a cast acrylic shell. It was then reinforced with a mixture of chopped fiberglass in a polyester resin applied to

the backside of the shell. The base of your unit was designed to give uniform support to the tub floor and has

been pre-leveled. It meets or exceeds load-bearing and impact resistance requirements of the listed standard

without evidence of crazing or cracking and with minimal deflection when installed in accordance to Laurel

Mountain Whirlpools printed instructions.

PRIOR TO INSTALLATION

Immediately inspect your tub upon arrival. If any damage has occurred, make a notation on the freight

carrier’s proof of delivery. DO NOT remove the bath from its shipping container until you are ready to water-

test and install. When you are prepared to remove the tub from its carton DO NOT LIFT the tub out by its

plumbing. We also recommend cutting cardboard from the shipping container to place inside the tub to

protect its floor. Even though your tub has been inspected and water tested prior to shipment, it

is very important that you perform a water test of your own to ensure all of the fittings and

SB4.18

Summary of content (8 pages)

PAGE 1
LAUREL MOUNTAIN – OWNER’S MANUAL For your installation, operation, and maintenance needs for all Colony units.
PAGE 2
LMW - Colony Collection Owner’s Manual connections were not damaged during transit. Take your tub to an area where you can fill it up, run electrical components, & drain it. Fill your tub to the overflow and if you have a pump and/or blower, operate it for 15 minutes. Inspect the entire unit during and after for leaks. Any defects that are discovered MUST be reported at this time to qualify for warranty coverage.
PAGE 3
LMW - Colony Collection Owner’s Manual Rough in the wiring on a single 120VAC, 20 amp, GFCI protected dedicated circuit for each whirlpool, air system, or heater installed on the tub. WARNINGS: 1) All electrical connections must be made by a licensed certified electrician in accordance with the requirements of the National Electrical Code and applicable state and local codes and procedures. 2) All circuits connected to this unit must be equipped with Ground Fault Circuit Interrupter (GFCI) protection.
PAGE 4
LMW - Colony Collection Owner’s Manual Laurel Mountain Whirlpools will not be held responsible for water damage of any kind in connection with the installation and/or operation of one of our bathtubs. All whirlpool jets must be completely submerged below water before starting the pump. Do not operate the pump without water as damage may occur. Do not block the overflow drain and allow water to reach the controls as they are not waterproof and leaks to the floor may occur.
PAGE 5
LMW - Colony Collection Owner’s Manual If your bath has a whirlpool system, simply pushing the push-button located on the tub will turn the tub on or off. The button next to it will cycle through the various speeds of the pump (low, medium, and high). Most jets may be adjusted by turning the jet ring/trim counterclockwise and the water flow will increase, while turning the jet trim clockwise will decrease the water flow. The jets can be closed if turned far enough clockwise.
PAGE 6
LMW - Colony Collection Owner’s Manual Whirlpool Inline Heater The inline heater is designed to MAINTAIN the temperature of the bath water between 101-104 degrees Fahrenheit. These limits cannot be increased or decreased. The Heater is operated by a pressure switch which is programmed into the heater. This switch allows the heater to operate only when there is sufficient water flowing through the system. DO NOT BYPASS THE SWITCH. This option is equipped with a molded plug on the end of a supply cord.
PAGE 7
LMW - Colony Collection Owner’s Manual Chromotherapy Mood Light The ColorGlo LED Multi-Color bath light comes pre-programmed with 10 light modes. To change modes, switch the unit off and then back on within 5 seconds. To resume a lighting mode, leave the unit switched off to save the last lighting mode displayed in memory. That same lighting mode will display the next time the unit is switched on. DO NOT attempt to service the electronic components yourself.
PAGE 8
LMW - Colony Collection Owner’s Manual Laurel Mountain Whirlpools Warranty This Laurel Mountain Whirlpools bath is warranted to the original purchaser to be free from defects in material and workmanship for the following periods. The bathtub shell carries a limited lifetime warranty. The pump, blower and heater have a limited 10 year warranty. All other parts have a limited 5 year warranty. Proof of purchase is required.