Installation Guide

EasyBase
™
Shower & Pan
Installation Instructions
Gelcoat & Solid Surface Bathware
A 10” X 10” X 1/2” DEEP BOX OUT (10” CORE DRILL) IS
REQUIRED TO BE CENTERED AROUND THE DRAIN PIPE.
INSURE THIS AREA IS PREPARED BEFORE INSTALLATION.
See Picture 1
1. Place the shower into the intended alcove to conrm
proper placement of the drainpipe and sizing of the above.
**HELPFUL TIP: PLACE TWO SECTIONS OF ½” PVC PIPE
ON FLOOR TO HELP SLIDE AND TILT UNIT INTO POSITION.
(REMOVE PVC PIPE BEFORE PROCEEDING TO STEP 2.
DRAW A LINE ON THE FLOOR WHERE THE FRONT OF THE
THRESHOLD LIES.
2. Remove the shower from the alcove by leaning it
forward, so that it can be laid on its front anges.
3. Clean the area of all dirt, trash, oil, grease, water and
other contaminants that may affect adhesion.
4. Apply solid wood ooring adhesive or 100% silicon
adhesive in a “zigzag” pattern with the space between the
sides (line), around 3/4” wide 1 1/2” to 2” apart.
5. Use 100% silicon construction adhesive or Polyurethane
Premium Construction adhesive ½” wide x 3/8” thick x
length to where the threshold of the shower will rest once
the unit is installed.
6. Secure area around drainpipe with insulation for re
code and to prevent bedding compound from owing
down to the oor below. Fill the 10” x 10” x ½” box out
(10” core drill) area with 100% silicone adhesive. Do not
over ll as this will prevent proper oor draft and may put
the drain area up causing unit not to drain properly. See
Picture 2
7. Install the drain provided in the shower prior to setting
it into its nal position, but do not store the shower on
its bottom while the drain is installed. **HELPFUL TIP:
TEMPORARILY REMOVE DONUT SEAL.
8. Set the shower into place and guide the drainpipe into
the drain by using the handle of a hammer or similar object.
No recess necessary
installation.
Shower framing alcove
with recess or pit built
into sub-floor.
10” area around drain
recessed1/2 inch
(Minimum)
10” area around drain
recessed1/2 inch
(Minimum)
Figure 2
No recess necessary
installation.
Shower framing alcove
with recess or pit built
into sub-floor.
10” area around drain
recessed1/2 inch
(Minimum)
10” area around drain
recessed1/2 inch
(Minimum)
Figure 3