Installation Guide

LMW - Colony Collection Owner’s Manual
Laurel Mountain Whirlpools Warranty
This Laurel Mountain Whirlpools bath is warranted to the original purchaser to be free from defects in material and
workmanship for the following periods. The bathtub shell carries a limited lifetime warranty. The pump, blower and
heater have a limited 10 year warranty. All other parts have a limited 5 year warranty. Proof of purchase is required.
This warranty is issued to the original purchaser and shall be effective from the date of purchase as shown on
purchaser’s receipt. Laurel Mountain Whirlpools will repair or replace (at their choice) any unit which proves to be
defective in material or workmanship under normal use and service, having been properly installed. This warranty is the
only express warranty made by Laurel Mountain Whirlpools and is limited to the duration of this warranty. Any labor
charges and/or damage incurred in installation, repair or replacement as well as incidental and consequential damages
connected therewith are excluded and will not be paid by Laurel Mountain Whirlpools. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty is void for any damage to the bath due to abuse, misuse, neglect, accident, improper installation, any
use violating instructions furnished by us, or repair not authorized in writing by Laurel Mountain.
WHIRLPOOL AIR BATH
PROBLEM
PROBLEM
SOLUTION
ON/OFF BUTTON
Won’t depress
BLOWER
-Fails to
operate
-Check electric power supply. Reset the
circuit breaker or replace fuse if
necessary. -
Check ground fault circuit interrupter.
Reset if tripped.
-If the system has been functioning for an
extended period of time, it is possible that
the thermic protection has shut off the
motor. Allow to cool off for at least 30
minutes before further use.
PUMP
-Won’t Start
-Motor hums
MOTOR
-Runs but no
air blown
through jets
Verify that the main air hose from the
manifold to the blower is properly
connected. If necessary, reconnect and
tighten clamps.
AIR
HEATER
-Does not
appear to
be working
-Fill the tub to working level & operate
blower on high for 5 minutes. Carefully
feel the flexible connection hose where it
connects to blower. The hose and its
immediate area should feel warm to the
touch, if not,call Laurel Mountain
Whirlpools
-If your tub is installed against 2 outside
walls, adequate insulation is
recommended to minimize heat loss.
LEAKS
-Pump Unions
-Pump o-ring
or seal
-Pipe to Jet
JET
Low/no water
pressure