Installation Guide

EasyBase
™
Shower & Pan
Installation Instructions
Gelcoat & Solid Surface Bathware
9. Level the shower and set plumb. If the oor is not level, it
will require the use of shims to level the shower. See Picture
5 If shims are required, they should be placed no more
than 6 inches apart to provide proper support. DO NOT
SHIM THE UNIT MORE THAN 1/8”. If the shower requires
more than 1/8” shim adjustment, the shower will need to be
pulled out and the oor will need to be leveled. Insure the
drain is lined up in the appropriate areas.
10. Secure the shower to the framing members through the
anges using 6D galvanized screws on 8” centers.
11. Cut a 2 x 4 member of 10” to place directly over the
drain area. Cut a 2 x 4 member to extend from the ceiling
to the 10” wooden block on the drain area. Protect the
shower surface by placing a towel under the wooded block.
12. Place the brace from the ceiling to the 10” piece of
wood. This should be a tight t. See Figure 5 continuous bead
of Liquid Nails Construction adhesive.
13. Repeat steps 11 through 12, for the threshold, pressing it
down to make complete contact with a continuous bead of
100% silicone adhesive.
Figure 4
Picture 1
Picture 2