Installation Guide

EasyBase

™

Shower & Pan

Installation Instructions

Gelcoat & Solid Surface Bathware

14. A torpedo level should be placed from oor to insure

the unit has proper slope and drainage. If unit does

not drain properly, the unit must be pulled back up to

determine where the problem lies. This should be done

immediately after step 14 before the materials have had a

chance to set.

15. Unit should be walked in and found to be stable and

without ex.

16. All bracing can be removed after 72 hours after Liquid

Nails Construction adhesive has been applied.

**THE DRAIN CONNECTION SHOULD BE TIGHTENED

AFTER THE FLOOR HAS BEEN BRACED, CURED, AND THE

BRACE REMOVED i.e. 72 HOURS AFTER INSTALL.

**CHECK THE FLOOR TO INSURE THERE ARE NO HIGH

SPOTS AND THE DRAFT HAS BEEN MAINTAINED.

See Picture 6

**ATTENTION: THE THRESHOLD MUST BE FLAT ACROSS

THE FULL WIDTH WITH NO BOW AND LEVEL TO THE

FLOOR.

Following the appropriate installation procedures is

imperative on this product. Not following these procedures

could result in product failure which will not be covered

under manufactures warranty.

2014, Laurel Mountain

Picture 5

Figure 5

Picture 6