Instructions / Assembly

12
ASSEMBLY INSTRUCTIONS
13
14
13. Connect one end of gas hose to the control box
assembly and regulator.
Connect one end of gas hose onto the thread of control
box assembly. Tighten both connexions.
Do not cross-thread.
Connect the other end of gas hose to the regulator.
Tighten them. Do not cross-thread.
WARNING! Ensure gas hose does not contact any high
temperature surfaces, or it may melt and leak causing
a fire.
14. Connect regulator to cylinder.Install cylinder,
and secure with the propane block belt tightly.
Complete installation.
Note:
The propane gas and cylinder are sold separately.
Warning:
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapour withdrawal
supply system. See chapter 12 of the standard for
storage and handling of liquefied petroleum gas,
ANS/NFPA 58 or CSA B149.1, Natural Gas and
Propane Installation Code. Your local library or fire
department should have this book.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated area out of the reach of children. A
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building,
garage or any other enclosed area. The maximum inlet
gas supply pressure: 250 PSI. The minimum inlet gas
supply pressure: 5 PSI is required for purpose of input
adjustment. The heater must have a minimum output
rating of 16,000 BTU/hr when it is not working at full
capacity. The pressure regulator and hose assembly
supplied with the appliance must be used. The
installation must conform with local codes, or in the
absence of local codes,with national fuel gas code,
ANS Z223.1/NFPA54, natural gas and propane
Installation Code, CSA B149.1, or propane storage
and handling code, B149.2.