Instructions / Assembly

16. Screw the regulator to the hose.

Install the gas cylinder

Open the door and put the gas cylinder onto the base,

then secure it with gas cylinder secure belt. And then

screw the regulator to the gas cylinder contector.

WARNING: Use a standard 20 lb. propane cylinder

only.

Use this heater only with a propane vapor

withdrawal supply system. See chapter 5 of the

standard for storage and handling of liquefied

petroleum gas, ANS/NFPA 58. Your local library or

fire department should have this book.

A minimum supply pressure of 0.4 P.S.I. is required

for the purpose of input adjustment for propane

gas. Storage of an appliance indoors is permissible

only if the cylinder is disconnected and removed

from the appliance. A cylinder must be stored

outdoors in a well-ventilated area out of the reach

of children. A disconnected cylinder must have dust

caps tightly installed and must not be stored in a

building, garage or any other enclosed area. The

minimum permissible gas supply pressure of 10

W.C. is required for purpose of input adjustment. A

minimum of 17,000 BTUs per hour is the required

input rating for a heater with a rating less than full.

The pressure regulator and hose assembly

supplied with the appliance must be used.

The installation must conform with local codes,

or in the absence of local codes,with national fuel

gas code, ANS Z223.1/NFPA54, natural gas and

propane Installation Code, CSA B149.1, or propane

storage and handling code, B149.2.

-10-

ASSEMBLY INSTRUCTIONS