ALTO DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department. WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. WARNING For Outdoor Use Only.
DANGER CARBON MONOXIDE HAZARD This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper, tent or home. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury, death or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.
NOTE:PLEASE READ THE FOLLOWING SAFETY RULES WARNING: Any guard or other protective device removed for servicing the heater must be replaced prior to operating the heater. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, NFPA58 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 Installation and repair should be done by a qualified service person.
NOTE:PLEASE READ THE FOLLOWING SAFETY RULES WARNING: Within a partial enclosure which includes an overhead cover and three side walls, as long as 30 percent or more of the horizontal periphery of the enclosure is permanently open. The pressure regulator and hose assembly supplied with the appliance must be used, replacement pressure regulators and hose assemblies must be those specified by the appliance manufacturer. This appliance requires 9kg(20lb) LP-gas supply cylinder.
NOTE: PLEASE READ THE FOLLOWING SAFETY RULES: Perform a leak test with a soapy solution: 1. To check gas connections. 2. After connecting a new cylinder. 3. Upon re-assembly after disassembly. This heater is designed to operate with a standard 20 Ib propane cylinder with Approved Cylinder Connection. Before beginning assembly of product, make sure all parts are present. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts.
PARTS LIST / EXPLODED VIEW 8 1 1 2 1 Burner Assembly 3 1 Upper Pole 4 1 Lower Pole 5 1 Desk surface 6 1 Pole supporting board 7 1 Cylinder Chain 8 3 M6 Nuts 9 6 6mm Washers 10 3 M6x70 Double Pointed Bolts 11 5 4mm Washers 12 5 M4x8 Bolts 13 6 M5x12 Bolts 14 6 5mm Washers 15 6 M5x12 Bolts 16 4 M6x14 Bolts Reflector 9 1 10 2 11 12 3 13 4 5 14 15 6 16 7 6
ASSEMBLY WARNING: Read ALL assembly instructions thoroughly and carefully to insure proper, safe assembly . Step 1 4 15 14 Step 1 Insert lower pole (4) into the pole supporting board (6) , fix it with 6 pcs 5mm washers (14) and 6 pcs M5x12 bolts (15) . 6 Hardware Used Step 2 15 M5 X 12 bolt X6 14 5mm washer X6 Step 2 Put the desk surface (5) in the lower pole (4) , fix it with 4 pcs M6×14 bolts (16).
ASSEMBLY Step 3 Connect the upper pole (3) on the lower pole (4), fix it with 6pcs M5x12 bolts (13) . Step 3 3 13 4 Hardware Used 13 M5X12 Bolt Step 4 Insert the burner assembly (2) in the upper pole (3), fix it with 5pcs 4mm washers (11) and 5pcs M4×8 bolts (12) .
ASSEMBLY Step 5 Install reflector assembly (1) , fix it with 3pcs M6×70 double pointed bolts (10)、 6pcs 6mm washers (9) and 3 pcs M6 nuts (8) . Step 5 8 9 1 9 2 Hardware Used 8 M6 Nut x3 9 6mm Washer x6 10 M6x70 Double Pointed Bolts Step 6 Step 6 Open the door ,Put cylinder into the big hole on bottom panel and lock the cylinder chain .
SAFETY CHECK Check for leaks Your patio heater has been checked at all factory connections for leakage. To check the connection at the gas hose/regulator /cylinder. 1) Make leakage solution by mixing 1part liquid dish soap and 3 parts water. OFF OFF GH HI GH HI 2) Spoon or brush several drops (or use squirt bottle) of the solution onto hose connection, regulator & cylinder connection. hose connection brush 3) Turn on gas cylinder valve. Inspect the connections and look for bubbles.
IGNITER BATTERY INSTALLATION Instruction For Installing Battery Remove igniter button by turning counter-clockwise.Install “AAA” battery with positive terminal up as indicated in diagram. Replace igniter button.
OPERATION WARNING: DO NOT ATTEMPT TO OPERATE HEATER UNTIL YOU HAVE READ AND UNDERSTAND ALL PRECAUTIONS . FAILURE TO DO SO CAN RESULT IN SERIOUS PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE. WARNING Before turning gas supply ON FOR YOUR SAFETY: If at any time you are unable to Your heater was designed and approved for OUTDOOR light burner and smell gas, wait 5 USE ONLY. DO NOT use it inside a building or any other minutes to allow gas to dissipate enclosed area. before attempting to light heater.
OPERATION 3) Push and turn the control knob counter-clockwise to the "PILOT" position. Depress the control knob. Push and hold the igniter button until the pilot lights. 4) Once the pilot is lit, release the igniter button and continue to depress the control knob for 30 seconds. 5) After depressing the control knob for 30 seconds, release the control knob and turn it counter-clockwise to the “LOW” or “HIGH” position.
OPERATION CAUTION : AVOID INHALING FUMES EMITTED FROM THE HEATER'S FIRST USE. SMOKE AND ODOR FROM THE BURNING OF OILS USED IN MANUFACTURING WILL APPEAR. BOTH SMOKE AND ODOR WILL DISSIPATE AFTER APPROXIMATELY 30 MINUTES. THE HEATER SHOULD NOT PRODUCE THICK BLACK SMOKE. NOTE: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the Control Knob to the "LOW" position. Then, turn the knob to the level of heater desired.
LOCATING HEADER FOR USE CAUTION: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT, ABOVE, BESIDE OR UNDER THIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE SERIOUSLY DAMAGED. This heater is primarily used for the heating of outdoor patios, decks, spas, pools and open working areas. Always make sure that adequate fresh air ventilation is provided. Follow the spacing tolerances shown in Figure 1 at all times. This heater must be placed on level, firm ground.
MAINTENANCE/STORAGE CLEANING AND MAINTENANCE : To enjoy years of outstanding performance from your heater make sure you perform the following maintenance activities on a regular basis: Keep exterior surfaces clean. Yellow Tip Primarily Blue Flame Use warm soapy water for cleaning. Never use flammable of corrosive cleaning agents. While washing your unit, be sure to keep the area around the burner and pilot assembly dry at all times. If the gas control is exposed to water in any way, do NOT try to use it.
MAINTENANCE/STORAGE Spiders and insects can nest in the burner or orifices. This dangerous condition can damage heater and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles. Carbon deposits may create a fire hazard. Clean dome and engine with warm soapy water if any carbon deposits develop. STORAGE: Between uses: Turn the control knob to "OFF" position. Turn LP cylinder to "OFF" position.
TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION Pilot will not light Gas valve may be OFF Turn the gas valve ON Tank fuel empty Refill LP gas tank Air in supply system Purge air from lines Loose connection Check all fittings Debris around pilot Clean dirty area Loose connection Tighten connection Thermocouple Contact customer service Gas leak in line Check connections Lack of fuel pressure Fuel tank is near empty Pressure is low Fuel tank is near empty Control valve not ON Turn valv
FIVE-YEAR LIMITED WARRANTY The appliance has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer purchaser that all aspects of this product will be free of defects in material and workmanship for five (5) year from the date of purchase. A replacement for any defective part will be supplied free of charge for installation by the consumer. Defects or damage caused by the use of other than genuine parts are not covered by this warranty.