Instructions / Assembly

ASSEMBLY INSTRUCTIONS

Standard 20 lb. tank

4. Connect hose and regulator to cylinder.

The propane gas and cylinder are sold separately.

Use a standard 20 lb. propane cylinder only.

Use this heater only with a propane vapor withdrawal

supply system. See chapter 12 of the standard for

storage and handling of liquefied petroleum gas,

ANSI/NFPA 58 or CSA B149.1, Natural Gas and

Propane Installation Code. Your local library or fire

department should have this book.

Storage of an appliance indoors is permissible only if

the cylinder is disconnected and removed from the

appliance. A cylinder must be stored outdoors in a

well-ventilated area out of the reach of children. A

disconnected cylinder must have dust caps tightly

installed and must not be stored in a building, garage

or any other enclosed area. The maximum inlet gas

supply pressure: 250 psi, The minimum inlet gas supply pressure: 5 psi. is required for

purpose of input adjustment. The minimum hourly of 16000 Btu/hr is required input

rating for a heater at ratings less than full input rating. The pressure regulator and

hose assembly supplied with the appliance must be used. The installation

must conform with local codes, or in the absence of local codes,with

national fuel gas code, ANSI Z223.1/NFPA54, natural gas and

propane Installation Code, CSA B149.1, or propane storage

and handling code, B149.2.

3. Propane Only-Proper Hose Connection.

WARNING! Ensure the hose does not contact

any high temperature surfaces, or it may melt

and leak causing a fire.