Assembly Instructions

Pre-Assembled
Beltrac
®
Posts
Assembly Instructions • Assembly Instructions • Assembly Instructions
Required Tools
During shipping, your Beltrac Post may
have loosend from the base.
Please tighten the post-to-base connection
before using your Beltrac Post.
1. Bottom rim of post tube should be flat
against base. See Figure A.
2. Tilt post on its side while maintaining
flush fit between post and base.
3. On bottom of the base: Tighten the
center hex bolt until tightly secured. See
Figure B.
4. Check placement of post on the base
and re-tighten hex bolt if neccessary.
5. Stand post upright and position post
for use.
NOTE: Allen wrench not included.
If you need one, please call customer
service at 800-624-6225 and we will
gladly send you one at no charge.
A
B
Parts List:
© Lavi Industries
All Rights Reserved.
87-042
0121 Pre-Assembled Beltrac Posts.
Beltrac Post