Use And Care Manual

User Manual of LV-N9808C8E Series NVR
34
built-in switch interfaces, you must disable 2 built-in switch interfaces in the Edit IP camera panel.
To add Cameras for NVR via built-in switch interfaces:
Before you start:
Connect the network cameras via the built-in switch interfaces.
Steps:
1. Enter the Camera Management interface.
Main menu> Camera> Camera
You can see the connected cameras are listed.
Figure 2. 20 List of Connected Cameras
Note: The cameras connecting to the built-in switch interface cannot be deleted in this menu.
2. Click the Edit button.
Figure 2. 21 Edit IP Camera Interface
Note: Plug-and-Play means that the camera is connected to the switch interface, so in this case, the
parameters of the camera can’t be edited. The IP address of the camera can only be edited in the Network
Configuration interface, see Chapter 9.1 Configuring General Settings for detailed information.