Use And Care Manual

User Manual of LV-N9808C8E Series NVR

2.1 Starting Up and Shutting Down the NVR

Purpose:

Proper startup and shutdown procedures are crucial to expanding the life of the NVR.

Before you start:

Check that the voltage of the extra power supply is the same with the NVR’s requirement, and the ground

connection is working properly.

Starting up the NVR:

Steps:

1. Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an

Uninterruptible Power Supply (UPS) be used in conjunction with the device.

2. Turn on the power switch on the rear panel.

3. After startup, the Power LED indicator turns on . A splash screen with the status of the HDD appears on the

monitor. The row of icons at the bottom of the screen shows the HDD status. ‘X’ means that the HDD is not

installed or cannot be detected.

Shutting down the NVR

Steps:

1. Enter the Shutdown menu.

Menu > Shutdown

Figure 2. 1 Shutdown Menu

2. Click the Shutdown button.

3. Click the Yes button.

4. Turn off the power switch on the rear panel when the attention pops up.

Figure 2. 2 Shutdown Attention

Rebooting the NVR

In the Shutdown menu, you can also reboot the NVR.

Steps:

1. Enter the Shutdown menu by clicking Menu > Shutdown.

2. Click the Logout button to lock the NVR or the Reboot button to reboot the NVR.