Use and Care Manual
www.LaViewUSA.com26
Conguring NTP Server
Purpose:
A Network Time Protocol (NTP) Server can be
congured on your NVR to ensure the accuracy of
system date/time.
Steps:
1. Enter the Network Settings interface.
Menu >Conguraon> Network
2. Select the NTP tab to enter the NTP
Settings interface, as shown in Figure 9.
13.
NTP Settings Interface
3. Check the Enable NTP checkbox to
enable this feature.
4. Congure the following NTP settings:
• Interval: Time between the two
synchronizing actions with NTP
server. The unit of time is in
minutes.
• NTP Server: IP address of NTP
server.
• NTP Port: Port of NTP server.
5. Click the Apply button to save settings
and exit the interface.
Note: The me synchronizaon interval can
be set from 1 to 10,080 min, and the default
value is 60min. If the NVR is connected to a
public network, you should use a NTP server
that has a me synchronizaon funcon, such
as the server at the Naonal Time Center (IP
Address: 210.72.145.44). If the NVR is set up
in a customized network, NTP soware can be
used to establish a NTP server used for me
synchronizaon.
Conguring RTSP
Purpose:
The RTSP (Real Time Streaming Protocol) is
a network control protocol designed for use in
entertainment and communications systems to
control streaming media servers.
Steps:
1. Enter the Network Settings menu
Menu >Conguraon> Network
2. Select the More Settings tab to enter the
More Settings menu
RTSP Settings Interface
3. Enter the RTSP port in the text eld
next to RTSP Service Port. The default
RTSP port is 554, and you can change it
accordingly.
4. Click Apply button to save settings and
exit the menu.
Conguring Server and HTTP
Ports
Purpose:
You can change the server and HTTP ports in the
Network Settings menu. The default server port is
8000 and the default HTTP port is 80.
Steps:
1. Enter the Network Settings interface.
Menu >Conguration> Network
2. Select the More Settings tab to enter
the More Settings interface, as shown in
Figure 9. 15.
More Settings Interface
3. Enter the Server Port and HTTP Port in
the text elds. The default Server Port is
8000 and the HTTP Port is 80, and you
can change them according to different
requirements.
4. Click Apply button to save settigns and
exit the interface.
Note: The Server Port should be set to the range of
2000-65535 and is used for remote client soware
access. The HTTP port is used for remote IE access.
Conguring Email
Purpose:
The system can be congured to send an email
notication to designated users if, an alarm motion
event is detected or if the administrator password
is changed.