Replacement Part List

Slot

Spool Cover

Spool

Tabs

Eyelets

SPOOL REPLACEMENT (See Figure 14)

■ Use only 0.080 in. diameter round monofilament line.

Use original manufacturer’s replacement line for best performance.

■ Remove the battery pack.

■ Push in tabs on side of spool cover.

■ Pull spool cover up to remove.

■ Remove spool.

NOTE: Always clean the spool cover and spool base before reassembling the trimmer head.

■ Check the spool cover, spool and spool base for wear. If necessary, replace the worn parts.

■ To install the new spool, make sure the line is captured in the anchor hole on the new spool.

Make sure the end of the line is extended approximately 6 in. beyond the slot.

■ Install the new spool so that the line and slot align with the eyelet in the line head. Thread the

lines into the eyelet.

■ Pull the line extending from the line head so the line releases from the slot in the spool.

■ Reinstall the spool cover by depressing tabs into slot in the line head and pushing down until

spool cover clicks into place.

NOTE: Use LawnMaster spool model # RS0606 for replacement.

LINE REPLACEMENT (See Figures. 15-18)

■ Remove the battery pack.

■ Remove the spool from the line head.

Fig. 14

Fig. 15

OPERATION