Use and Care Manual

OPERATION

Cutting device - advancing the trimmer line (Figs. 6)

In order to advance a length of trimmer line, firmly tap the bump cap on the lawn while the trimmer

is running. This will automatically advance a new length of trimmer line and trim the line to the

correct length. A firm but gentle motion should be used when tapping the bump cap on the lawn.

This advancing process may be repeated as often as necessary. Never try to advance the line on

a hard surface such as a sidewalk or driveway. If unit fails to advance, unplug power from trimmer

and clean the bump cap both inside and out.

Flower Guard

Pull the flower guard out of the trimmer head (Fig.7). If the flower guard is no longer required, it can be

pushed in again (park position).

Using the flower guard

The grass trimmer is equipped with a flower guard that can be lowered to push flowers away from

the cutting line so they are protected (Fig.8). The flower guard is an indicator of the maximum

cutting range of the line.

Fig. 7

Fig. 8

Fig. 6