User Guide

TOOLS REQUIRED:

• Phillips head screwdriver

INSTRUCTIONS:

Step 1

Begin by lifting sign and placing the adapter

on the TensaBarrier post top.

Step 2

Adapter slots should line up with the belt

receivers on post.

Step 3

Using your Phillips head screwdriver, tighten

the screw on the adapter, thereby tightening

the sign to the post.

Step 4

Test the sign by trying to turn the adapter by

hand, if adapter moves you should continue to

tighten.

Sign is now ready for use.

ATTACHING THE SIGN ASSEMBLY TO THE

TENSABARRIER

POST

Step 1

Step 2

Step 3

Step 4

Lawrence Metal Products Inc. • 800.441.0019 • 631.666.0300 • Fax: 631.666.0336 • www.lawrencemetal.com

e-mail: service@lawrencemetal.com • PO Box 400-M • 260 Spur Drive South, Bay Shore, New York 11706-0779 USA

PAGE 1
ATTACHING THE SIGN ASSEMBLY TO THE TENSABARRIER® POST TOOLS REQUIRED: • Phillips head screwdriver INSTRUCTIONS: Step 1 Begin by lifting sign and placing the adapter on the TensaBarrier post top. Step 1 Step 2 Step 2 Adapter slots should line up with the belt receivers on post. Step 3 Using your Phillips head screwdriver, tighten the screw on the adapter, thereby tightening the sign to the post. Step 4 Test the sign by trying to turn the adapter by hand, if adapter moves you should continue to tighten.