BL-R8822BU1-A IEEE 802.11a/b/g/n/ac 2T2R USB WiFi Module and Bluetooth SPEC Shenzhen Bilian Electronic Co.
1.1Features: Operating Frequencies : 2.4~2.4835GHz and 5.15~5.85GHz 1.2 Reserving System IEEE Std. 802.11a IEEE Std. 802.11b IEEE Std. 802.11g IEEE Std. 802.11n IEEE Std. 802.11ac Bluetooth 2.1/3.0/4.0/4.2 1. 3Chip Solution Realtek:RealtekRTL8822BU 2. 结构大小Size 3. 17.8mm x27.0mm x 2.
4. Introduction BL-R8822BU1 module design is based on Realtek RTL8822BU solution, The RTL8822BU is a highly integrated single chip which has built in a 2x2 dual-band wireless LAN radio and Bluetooth radio.It includes Bluetooth EDR and LE radio which complies with Bluetooth v2.1+EDR, v3.0, v4.0+BLE andV4.2.The Module is a highly integrated MAC/BBP and 2.4/5GHz PA/LNA single chip which supports a 866.7Mbps PHY rate.
.2 Product Technical Specifications 5. Mechanical Specification 5.1 Mechanical Outline Drawing Typical Dimension (W x L ): 17.8mmx 27.0mm x 2.4mm General tolerance: ±0.
.2Pin Assignments 4
Antenna WIFI:Connect to external antenna through the connector,The gain of the external antenna is 2dBi, the length of the antenna is 200mm, the internal structure is copper tube structure. Antenna manufacturer: Shenzhen Bilian Electronic Co.,Ltd. External antenna model: Black knife antenna Antenna gain:2dBi WIFI Antenna BT Antenna BT:The module needs to be attached to the PCB board and connected to the external antenna through the PIN 30 solder joint of the circuit on the PCB.
.Package 6
. introduction Indoor use only FCC Statement FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 ,15.407 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Contains FCC ID: 2AL6K-R8822BU1-A” When the module is installed inside another device, the user manual of the host must contain below warning statements; 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.