User Manual

Install the 2-Circuit Monorail to Standoffs
3
Remove the housing cap on all standoffs.
HOUSING CAP
Place a section of the 2-Circuit Monorail into standoff
housings.
While supporting the 2-Circuit Monorail, tighten the housing
cap completely to the standoff housings to secure the
2-Circuit Monorail in place.
Repeat steps 2 and 3 for the remaining standoffs.
NOTE: In case of cross threading, loosen the cap and
repeat step 3.
STANDOFF HOUSING
2-CIRCUIT MONORAIL
HOUSING CAP
1A3A
1
2
1
2
1A3B
3
4
3