Owner's manual

Installation Instructions for
"T" Conductive Connectors
1.0
TCONNECTOR_-M-2
980MR2TCN
1
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL 2-Circuit Monorail
system only.
The "T" conductive connectors connect three sections of the
2-Circuit Monorail end to end.
Push the three Monorail sections completely onto the three
"T" conductive connectors
A SECTION OF
A MONORAIL
"T" CONDUCTIVE
CONNECTOR
Tighten all nine M3 set screws with the 1.5 MM Allen wrench.
Make sure all set screw connections are tight for a proper
power connection and to avoid heat build up.
1.5 MM ALLEN
WRENCH
M3 SET
SCREW
Install the "T" Conductive Connectors
A SECTION OF
A MONORAIL
A SECTION OF
A MONORAIL
2-Circuit Monorail
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVETHESE INSTRUCTIONS!
A Generation Brands Company
1B
1A
1
2
1B
1A
1
1
1
2
2