Installation Guide

1.6

Installation Instructions for

Hello

700KHELL0_

920KHELLO

GENERAL PRODUCT INFORMATION:

This product is suitable for indoor dry locations only.

This product should be used with Tech Lighting Kable Lite

system only.

HEADS-LOW VOLTAGE

MR16 LAMP

TYPICAL LAMP PIN

CAP

GLASS LENS OR

LOUVER (OPTIONAL

NOT INCLUDED)

TYPICAL

SOCKET PIN

LOUVER HOLDER

Installing The Lamp

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

Use MAX 50 Watt, MR16 Front Cover Halogen

Lamp.

Unscrew and remove the cap from the louver holder.

Push the MR16 lamp pins completely into the socket

pins.

Place the Louver (optional, not included) or the glass

lens (optional, not included) in front of the lamp, into

the louver holder.

NOTE: Use only your fingers and a soft cloth to

replace the lamp.

CAP

LOUVER HOLDER

Screw the cap back onto the louver holder.

PAGE 1
920KHELLO Installation Instructions for Hello 700KHELL0_ 1.6 HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is suitable for indoor dry locations only. This product should be used with Tech Lighting Kable Lite system only. Installing The Lamp 1B C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: Use only your fingers and a soft cloth to replace the lamp. Use MAX 50 Watt, MR16 Front Cover Halogen Lamp.
PAGE 2
Installing the Fixture IMPORTANT SAFETY INSTRUCTIONS 2A To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: THUMB SCREW FIXTURE CONNECTOR – Use this fixture indoors only. – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm. 3 2 – Risk of fire: Use only the type of lamp and maximum wattage indicated in this instruction manual.