Installation Guide

ManualsBrandsLBL Lighting ManualsChandeliersPhoton 34 in. W 23.5-Watt Satin Nickel Integrated LED Chandelier

Installation Instructions for

Ceiling Canopy (Compact Fluorescent & )LED

Preparing the Canopy

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

#8-32

SCREW

CROSSBAR

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

Remove the crossbar from the canopy by completely

unscrewing the strain relief.

STRAIN RELIEF

CROSSBAR

CANOPY

SET SCREW

Loosen the set screw on the strain relief.(Do Not Remove)

980CKCDCF

1.3

CKCDCF

2 2

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
980CKCDCF Installation Instructions for Ceiling Canopy (Compact Fluorescent & LED) CKCDCF 1.3 GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
Install the Fixture (No Suspension Cables) Install the fixture (With Suspension Cables) NOTE: Make sure to support the fixture while Note: For canopies with suspension cables, skip section 2 and continue on section 3. adjusting the aircraft cables. An assistant is recommended to complete the remaining steps. 2A 1A 3A 1A POWER CORD STRAIN RELIEF 3 CANOPY CANOPY 11 CABLE CLUTCH STRAIN RELIEF CORD 1 4 SET SCREW AIRCRAFT CABLE 1 Feed the aircraft cable(s) through the cable clutch in the canopy.
PAGE 3
Install the Canopy Connect the Power (Compact Fluorescent) 4A 1A 5A 1A 3 3 5 4" 4 BALLAST 2 1 Leave 6" of the cord behind the canopy for power connections. Cut the excess cord. 1 Connect the red ballast wire to one of the insulated pendant wires with a wire nut. 2 From the end of the cord, strip the insulation 4" using a sharp knife. Make sure not to nick the inner wires. 2 Connect the yellow ballast to the other insulated pendant wire with a wire nut. 3 Strip the end of the wires.
PAGE 4
Complete Installation 7A 1A SET SCREW STRAIN RELIEF CORD NOTE: It is recommended that one person hold the fixture while the electrician finishes the installation. 1 Place all wires, wire nut connections, ballast/driver, and the secondary strain relief properly inside the canopy. 2 Loosen the set screw on the primary strain relief. 3 Align the canopy center hole with the crossbar center hole.