Installation Guide

3
Install the Canopy
4"
Leave 6" of the cord behind the canopy for power
connections. Cut the excess cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. .Make sure not to nick the inner wires
Strip the end of the wires.
Feed the fixture wires through the crossbar center hole
and then pull them out of the electrical box.
Note: If the cord has a cloth cover, peel back or remove
the cloth where the secondary strain relief is installed.
Install the secondary strain relief by first feeding the
power cord through it.
Snap the strain relief tab into place.
Pull the cord to take up the slack and fit the rest of the
cord in the strain relief’s openings.
TAB
1A4A
1A
4B
1
2
3
4
5
6
7
5
6
7
7
4
Connect the red ballast wire to one of the insulated
pendant wires with a wire nut.
Connect the yellow ballast to the other insulated
pendant wire with a wire nut.
Connect the fixture and the crossbar ground wire to a
suitable ground in accordance with local electrical
codes.
Connect the white ballast wire to the neutral power line
wire with a wire nut.
Connect the black ballast wire to the hot power line
wire with a wire nut. Skip to section 7A
BALLAST
1A5A
1
2
3
4
5
2
1
4
5
3
3
Connect the Power (Compact Fluorescent)
Connect the Power ()LED
1A6A
Connect the negative driver wire (labeled -) to the
pendant wire with white tracer (white wire) with a wire
nut.
Connect the positive driver wire (labeled +) to the
remaining pendant wire (black wire) with a wire nut.
Connect the fixture and the crossbar ground wire to a
suitable ground in accordance with local electrical
codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
DRIVER
1
2
3
4
5
2
1
4
5
3
3