Installation Guide

SAVETHESE INSTRUCTIONS!

Adjust the Suspension Cables

(Optional for Multiple Suspension

Cable Canopies)

Adjust the aircraft cables until the fixture is level; feed

the cable into the cable clutch to raise the fixture and

push in on the cable clutch nipple to release the cable

and lower the fixture.

Place all wires, wire nut connections, ballast/driver, and

the secondary strain relief properly inside the canopy.

Loosen the set screw on the primary strain relief.

Align the canopy center hole with the crossbar center

hole.

Slide the canopy up against the ceiling and secure it in

place by tightening the primary strain relief into the

crossbar. Do not turn the cord.

Push the cord into the canopy and line up the marked

point on the cord with bottom of the primary strain

relief.

Tighten the plastic set screw to secure the cord.

STRAIN RELIEF

NOTE: It is recommended that one person hold the

fixture while the electrician finishes the installation.

CORD

SET SCREW

1A7A

CABLE

CLUTCH

CABLE

CLUTCH

7400 Linder Ave, Skokie, 60077IL

800.323.3226 - 847.626.6300

www.generation-brands.com

graphic is a registered trademark of Generation Brands. Generation Brands

reserves the right to change specifications for product improvements without

notification.

A Generation Brands Company

Complete Installation