Installation Guide

1E
CORD GRIP
FIXTURE CORD
CAP
CANOPY
MARKED POINT
2
Secure the mounting plate to the anchors with the provided
#8 screws.
#8 SCREW
For each of the canopies cord grips unscrew the caps.
CAP
CORD GRIP
CANOPY
CORD GRIP
Feed the fixture cord through the cap and cord grip into the
canopy.
Adjust the fixture height (from bottom of the fixture shade to
top of the canopy) by moving the fixture cord up or down.
FIXTURE CORD
When desired height is achieved, slightly tighten the cap.
From inside the canopy mark the cord right behind the cord
grip for the strain relief location.
Loosen the cap and feed the cord through the strain relief.
Place the strain relief right above the marked point and tighten
the slot head screw.
Slide the canopy against the strain relief and tighten the cap to
the cord grip.
For power connection, leave at least 1’ of the cord exposed in
the back of the canopy.
Cut off excess cord with a sharp cutter.
CAP
CANOPY
CAP
CORD GRIP
CANOPY
SLOT HEAD
SCREW
STRAIN
RELIEF
MARKED POINT
1F
1G
1H
1I
18
1
9
1
10
1
11
1
12
113
1
14
115
1
16
1
17
8
8
8
8
9
10
13
12
15
16
1
18