Installation Guide

From the end of the cord, strip the outer insulation 4" using a

sharp knife. Make sure not to cut inner wires.

Strip 1/4" of insulation from the inner insulated wires.

Insert one end of the safety cable into the mounting plate

safety bracket and insert the other end into the housing safety

bracket.

NOTE: It is recommended that one person holds the

canopy while the electrician finishes the installation.

MOUNTING

PLATE

SAFETY CABLE

SAFETY

BRACKET

HOUSING

MOUNTING

PLATE

SAFETY

CABLE

SAFETY

BRACKET

HOUSING

Make sure the mounting plate is grounded in accordance with

local electrical codes.

Connect the neutral suspension cords to the neutral power

line wire and secure with a wire nut.

Connect the hot suspension cords to the hot power line wire

and secure with a wire nut.

Place all wires and wire nut connections properly inside

the housing.

#8-32 SCREW

Slide the housing onto the mounting plate and line up the

housing holes with the mounting plate holes.

Replace and tighten the #8-32 screws to secure the housing in

place.

119

121