Installation Guide

1A1B

Installation Instructions for

Siena Wall

950WSSIENA

Install the Mounting Plate

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can mount either to a 4” square electrical box with a

round plaster ring or an octagon electrical box.

This instruction shows a typical installation.

Unscrew and remove the 2 mounting plate screws.

Remove the mounting plate from the fixture base.

MOUNTING

PLATE

MOUNTING

PLATE

SCEW

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

MOUNTING

PLATE

#8-32 SCREW

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1.0

C 003_W

1 1

PAGE 1
Installation Instructions for 950WSSIENA Siena Wall CW003_ GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can mount either to a 4” square electrical box with a round plaster ring or an octagon electrical box. This instruction shows a typical installation. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Install the Fixture 1C 1A 3A 1A 1 5 CANOPY FUSION JACK CONNECTOR 4 6 FIXTURE FUSION JACK CONNECTOR 4 Connect the fixture to a suitable ground in accordance with local electrical codes. 1 Follow the instruction provided with the pendant to shorten the cable. 5 Connect the available white fixture wire to the neutral power line wire with a wire nut. 2 Screw the Fixture Fusion Jack male connector into the Fusion Jack female connector.