Installation Guide

2
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the available white fixture wire to the neutral
power line wire with a wire nut.
Connect the available black fixture wire to the hot
power line wire with a wire nut.
Properly place the transformer, wires, and wire nut
connections into the electrical box.
Mount the fixture by sliding it back onto the mounting
plate and reinstalling the two fixture screws (reversal of
figure 1A).
Adjust the Canopy
Note: Depending on the size of the shade and the
desired distance of the shade from the wall,
Adjustments of the canopy length can be made
using this section. It is important to plan out the
desired height of the pendant along with the desired
distance from the wall before shortening the cable.
If needed, adjust the canopy arm’s length by loosening
the top and bottom set screws, pull the arm out to the
desired position, and secure it in place by re tightening
the set screws.
CANOPY ARM
SET SCREW
ALLEN WRENCH
Install the Fixture
1
Follow the instruction provided with the pendant to
shorten the cable.
Screw the Fixture Fusion Jack male connector into the
Fusion Jack female connector.
CANOPY FUSION JACK
CONNECTOR
FIXTURE FUSION JACK
CONNECTOR
1
Tap the touch dimmer to dim the fixture.
TOUCH
DIMMER
1A1C
5
6
7
8
4
5
6
4
1A2A
1
1
1
1A3A
1A3B
2
1
3
SAVETHESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.generation-brands.com
© 2014 Generation Brands.All rights reserved.The "Genereation Brands"
graphic is a registered trademark of Generation Brands. Generation Brands
reserves the right to change specifications for product improvements without
notification.
A Generation Brands Company