Owner manual

ManualsBrandsLBL Lighting ManualsLightingDahling

Installation Instructions for

Dahling Pendant

980FSJDHLNG

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Fusion Jack™

1.1

HS616_

SOCKET

LAMP

NOTE: Use only your fingers to install the lamp.

Push the lamp pins completely into the socket holes.

Use MAX 50 Watt Type Xelogen

(Xenon) Bi-Pin Lamp.

CAUTION: RISK OF FIRE

Never replace a Xenon lamp with a regular Halogen lamp.

A Halogen lamp requires a protective glass shield.

Assemble the Fixture

Place the hardware inside the glass shade and install the

three mounting rods by screwing them in completely.

MOUNTING ROD MOUNTING ROD

GLASS

SHADE

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSJDHLNG Dahling Pendant HS616_ 1.1 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Adjust the Fixture Height 2A 2E 6 ALLEN WRENCH SET SCREW CONICAL CONNECTOR 1 OUTER WRAPPED WIRE STOPS HERE Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 1 Feed and push the coaxial cable into the conical connector. The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
PAGE 3
B 2H 10 10 SOCKET Firmly tighten the set screw on the conical connector. LAMP 2I 1 NOTE: Use only your fingers to replace the lamp. 11 Use MAX 50 Watt Type Xelogen (Xenon) Bi-Pin Lamp. 11 Pull the coaxial cable toward the fixture to smooth the wrinkles. 2 Remove the old lamp. 3 Push the new lamp pins completely into the socket holes. Replacing the Lamp CAUTION: RISK OF FIRE 3A Never replace a Xenon lamp with a regular Halogen lamp. A Halogen lamp requires a protective glass shield.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.