User Manual

ManualsBrandsLBL Lighting ManualsLightingFiona 18 Flush Mount CF

Installation Instructions for

Fiona 18 Ceiling (Compact Fluorescent)

1.0

980FIONA18CCF

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TOTHE

ELECTRICAL BOX OFF.

Ceiling

FM700_CF

GP I :ENERAL RODUCT NFORMATION

This product can mount to either a 4” square electrical box with a

round plaster ring or an octagon electrical box.

This product is suitable for damp locations.

This instruction shows a typical installation.

Install the Shade

Install the shade by aligning the screws on the shade

with the holes on the fixture and secure them together

using the provided knurled nuts.

TOP VIEW

SHADE

FIXTURE

1 1

Install the Fixture

Remove the mounting plate from the fixture base by

unscrewing the two knurled nuts from the two

threaded studs.

MOUNTING PLATE

STUD

KNURLED NUT

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FIONA18CCF Fiona 18 Ceiling (Compact Fluorescent) FM700_CF Ceiling GENERAL PRODUCT INFORMATION: This product can mount to either a 4” square electrical box with a round plaster ring or an octagon electrical box. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF. This product is suitable for damp locations.
PAGE 2
D 2B MOUNTING PLATE MOUNTING PLATE FIXTURE ELECTRICAL BOX 7 7 KNURLED NUT 2 STUD 2 #8-32 SCREW #8-32 SCREW 2 Mount the mounting plate to the electrical box with 6 Properly place all wires and wire nut connections into 2 the two #8-32 screws. the electrical box. 7 Mount the fixture onto the threaded studs on the 2 mounting plate and secure it by tightening the two knurled nuts.
PAGE 3
Install the Lamps and Diffuser 3B 3A THREADED NIPPLE STEEL WASHER LAMP PLASTIC WASHER SOCKET DIFFUSER CAP C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 2 Unscrew the diffuser cap and remove it along with the washers from the socket assembly. 3C NOTE: To re-lamp, reverse the section 3 instructions to remove the diffuser and gain access to the lamps and sockets. Use MAX 32 Watt GX24Q-3 Base Triple Tube Compact Fluorescent Lamp.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.