Installation Guide

ManualsBrandsLBL Lighting ManualsFlush Mount LightsCrest 12 30-Watt Satin Nickel Integrated LED Flush Mount

Installation Instructions for

Crest Flush Mounts

1.0

980CRESTC

Ceiling

894, _LEDFM FM895, FM896

Install the Mounting Plate

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

This fixture are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low voltage electronic dimmer.

This product may be ceiling or wall mounted.

Separate the fixture base from the shade by unscrewing

and removing the three fixture screws using an Allen

wrench.

FIXTURE

SCREW

ALLEN

WRENCH

SHADE

MOUNTING

PLATE

Remove the mounting plate from the fixture base by

unscrewing the two knurled nuts from the two threaded

studs.

KNURLED NUT

FIXTURE

BASE

FIXTURE

BASE

THREADED

STUD

MOUNTING

PLATE

Connect the fixture to a suitable ground in accordance

with local electrical codes.

Mount the mounting plate to the electrical box with the

two #8-32 screws.

#8-32 SCREW

ELECTRICAL

BOX

Summary of content (2 pages)

PAGE 1
Installation Instructions for 980CRESTC Crest Flush Mounts FM894, FM895, FM896_LED 1.0 Ceiling GENERAL PRODUCT INFORMATION: This fixture are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low voltage electronic dimmer. This product may be ceiling or wall mounted.
PAGE 2
1D 1F THREADED STUD FIXTURE BASE 6 10 10 6 FIXTURE SCREW KNURLED NUT DRIVER 5 Feed the driver and power line wires through the fixture base center hole. 6 Install the fixture base onto the mounting plate studs and secure it in place with the knurled nuts. ALLEN WRENCH 9 Feed the driver, wires, and wire nut connections back through the fixture base center hole and into the electrical box.