Installation Guide

Installation Instructions for

Apex Swivel

1.4

HD162_1A50FSJ

980FSJAPXS

Install the Lamp

LAMP

SOCKET

NOTE: To reduce the risk of a burn or electric shock

during relamping, disconnect the power to the fixture.

Use Watt MR16 Front Cover

MAX 50

Halogen Lamp.

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Colored and Dichroic lenses, or Diffuser, Linear Spread, and Soft

Focus Lenses, or Structure Louvers are the compatible accessories.

Loosen the thumb screws on the socket.

Slide the socket back.

THUMB

SCREWS

ACCESSORY LENS

Push the MR16 lamp pins all the way into the socket.

Put the optional accessory lens into the ring.

Slide the socket forward so that the edge of the lamp sits

inside the ring.

Tighten the thumb screws on the socket.

WARNING: Risk of Fire. Hot Surface. Install the fixture

at least 6" (Inches) away from wall, curtains and combustible

materials. Maintain at least 9" (Inches) of clearance directly in

front of the fixture.

AVERTISSEMENT: Risque du feu. Surface Chaude.

Installez le montage au moins 6" (Pouces), 153 mm, loin du

mur, des rideaux et des matériaux combustibles. Maintenez au

moins 9" (Pouces), 230 mm, de dégagement directement

devant le montage.

Fusion Jack™

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

PAGE 1
Installation Instructions for 980FSJAPXS Apex Swivel HD162_1A50FSJ Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Colored and Dichroic lenses, or Diffuser, Linear Spread, and Soft Focus Lenses, or Structure Louvers are the compatible accessories. at least 6" (Inches) away from wall, curtains and combustible materials.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time.This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. Two Tips For Prolonging Halogen Lamp Life – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm.