Installation Guide

ManualsBrandsLBL Lighting ManualsLightingSophia Coax 1-Light Amber Satin Nickel Hanging Mini Pendant

Adjust the Fixture Height

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Fusion Jack™

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

SET SCREW

ALLEN WRENCH

Tap the conical connector on a hard surface with the set screw

facing down, so the plate inside drops into place.

SURFACE

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb and

forefinger.

PLATE

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWERTO THE

ELECTRICAL BOX OFF.

SET SCREW

ALLEN WRENCH

CONNECTOR

Installation Instructions for

Sophia

1.2

HS266_

980FSJSPHP

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSJSPHP Sophia HS266_ 1.2 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
1E 1H 6 10 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 6 10 1F INNER WIRE STOPS HERE Firmly tighten the set screw on the conical connector. 1I 7 11 WRINKLE ON OUTER WRAPPED WIRE 11 7 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.
PAGE 3
Install the Lamp 2A 2C SUCTION CUP 1 LAMP SUCTION CUP TAB NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 4 4 Use MAX 35 Watt MR16 Front Cover Halogen Lamp. 1 Push the suction cup onto the lamp front cover. 2B SOCKET 2 LAMP SUCTION CUP 2 Align the lamp pins with socket holes. 3 Push the lamp pins completely into the socket holes. 3 Remove the suction cup by pulling on the tab.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.