User Manual

ManualsBrandsLBL Lighting ManualsLightingMini-Isis Cylinder

Installation Instructions for

Mini Isis

980FSJMISISP

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Fusion Jack™

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWERTO THE

ELECTRICAL BOX OFF.

Adjust the Fixture Height

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

SET SCREW

ALLEN WRENCH

Tap the conical connector on a hard surface with the set screw

facing down, so the plate inside drops into place.

SURFACE

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb and

forefinger.

PLATE

SET SCREW

ALLEN WRENCH

CONNECTOR

1.1

HS545_

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSJMISISP Mini Isis HS545_ 1.1 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
1E 1H 6 10 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 6 10 1F INNER WIRE STOPS HERE Firmly tighten the set screw on the conical connector. 1I 7 11 WRINKLE ON OUTER WRAPPED WIRE 11 7 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.
PAGE 3
Install the Lamp 2A 2C GLASS SOCKET NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 1 Lift the glass to expose the socket. 2B 3 NOTE: Use only your fingers and soft cloth to replace the lamp. Use MAX 50 Watt,Type Xelogen (Xenon) Bi-Pin Lamp. 2 Push the lamp pins completely into the socket holes. WARNING: RISK OF FIRE Never replace a Xenon (Xelogen) lamp with a regular Halogen lamp.A regular Halogen lamp requires a protective glass shield.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.