User guide

ManualsBrandsLBL Lighting ManualsLightingMini-Rhythm D

Installation Instructions for

Mini-Rhythm Pendant (LED)

980FSJMRYTHD

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Fusion Jack™

1.1

HS762_LED

SOCKET

NOTE: Use only your fingers to install the lamp.

Screw the lamp into the socket.

Assemble the Fixture

Place the hardware inside the glass shade and install the

three mounting rods by screwing them in completely.

MOUNTING ROD MOUNTING ROD

GLASS

SHADE

The lamp is rated at 6 watts at 12 volts.

LAMP

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSJMRYTHD HS762_LED Mini-Rhythm Pendant (LED) 1.1 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. CAUTION - RISK OF FIRE This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Adjust the Fixture Height 2E 2A 6 ALLEN WRENCH SET SCREW CONICAL CONNECTOR 1 OUTER WRAPPED WIRE STOPS HERE Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench. 1 Feed and push the coaxial cable into the conical connector.The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector.
PAGE 3
Replacing the Lamp 2H NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 10 3A 10 Firmly tighten the set screw on the conical connector. SOCKET 2I GLASS SHADE LAMP 11 11 Pull the coaxial cable toward the fixture to smooth the wrinkles. NOTE: Use only your fingers to replace the lamp. The lamp is rated at 6 watts at 12 volts. 3 1 Unscrew and remove the old lamp. 2 Screw the new lamp into the socket.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2013 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.