Manual

CONDUIT
2
Install the Remote Transformer
TRANSFORMER
COVER
PHILLIPS SCREW
Remove the four Phillips screws to remove the
transformer cover.
Secure the transformer housing in place (hardware not
included).
Install a conduit and power line wires from the panel to
the remote transformer.
Do not connect the power line wires to the panel at this
time.
Make sure the transformer housing is grounded in
accordance with local electrical codes.
Connect the transformer white wire to the neutral power
line wire with a wire nut.
Connect the transformer black wire to the hot power line
wire with a wire nut.
2
NOTE: In order to use small gage wires from the
transformer to the electrical box, it is recommended to
install the remote transformer near (if possible) the
electrical box. See "Low Voltage Wire Size Table"
below.
1
2
3
4
5
6
7
1A1A
1A
1B
1 1
1
1
2
3
4
6
7