Manual

ManualsBrandsLBL Lighting ManualsLightingNikko CF8

Installation Instructions for

Nikko (18 Watt Compact Fluorescent)

1.0

148_HE, 149_HE, 159_HE

980NIKKOCF8

Install the Fixture

GP I :ENERAL RODUCT NFORMATION

This product is suitable for wet locations.

This instruction shows a typical installation.

Feed the power line wires through the crossbar nipple.

NIPPLE

POWER LINE

WIRE

Attach the crossbar to the electrical box using two #8-32

screws provided.

NIPPLE

#8-32 SCREW

CROSSBAR

Outdoor

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1B1A

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980NIKKOCF8 Nikko (18 Watt Compact Fluorescent) 148_HE, 149_HE, 159_HE Outdoor GENERAL PRODUCT INFORMATION: This product is suitable for wet locations. This instruction shows a typical installation. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors.
PAGE 2
1C COVER 1E SCREW 3 3 7 NUT 3 WASHER NIPPLE 3 7 3 Remove all the screws from the front of the fixture. 4 Lift the cover off of the fixture. Make sure the fixture base is level, and secure it to the nipple with a lock washer and nut. 1F 1D 8 9 FIXTURE BASE 5 5 SCREW REFLECTOR 5 Remove the screws on the reflector. 6 Lift the reflector out of the fixture base. 2 8 Connect the hot power line wire to the black ballast wire with a wire nut.
PAGE 3
Install the Lamp and Cover 2B 2A 1 3 C AUTION:To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. Caulk around the base with waterproof construction sealant. 2C Use MAX 18 Watt type quad tube G24Q-1 base compact fluorescent lamp. 1 Push the lamp base into the socket. 2 Before continuing, turn on power to the fixture to verify all connections are good. 4 3 4 4 4 4 Replace the cover and reattach the screws to secure the cover to the fixture.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.