Installation Guide

Installation Instructions for

980NATEO

Install the Fixture

1.0

__OD1006 , OD1007

Wall

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for wet locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Nate 9 and 17 Outdoor

Remove the two fixture screws on the top and bottom

of the fixture.

Remove the mounting plate from the fixture base.

SCREW

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

MOUNTING

PLATE

MOUNTING

PLATE

SCREW

PAGE 1
Installation Instructions for 980NATEO Nate 9 and 17 Outdoor OD1006_, OD1007_ Wall GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
1C 1D 4 5 6 4 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the white fixture wire to the neutral power line wire with a wire nut. 6 Connect the black fixture wire to the hot power line wire with a wire nut. 7 Properly place all wires and wire nut connections into the electrical box and reinstall the fixture base onto the mounting plate (reversal of step 1A).