Instruction Manual

ManualsBrandsLBL Lighting ManualsLightingTube 3

Installation Instructions for

Tube 3

1.2

HS2933FR_1B35MRL

980MRLTUB3P

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

This product is intended to be used with LBL Monorail system.

(H)

Connect the Fixture Arms

The overall fixture height (H) is measured from bottom of the

bottom glass shade to the end of the fixture Fusion Jack.

Determine the overall desired fixture height.The height (H1) is

from the bottom of the top shade to the end of the fixture

Fusion Jack and it is 39" inches when the fixture rods are

not cut.

GLASS SHADE

FIXTURE

FUSION

JACK

(H1)

Mark amount (LI) from one end of the fixture rod that needs

to be cut shorter. (Optional)

M3 SET

SCREW

1.6 MM

ALLEN

WRENCH

SOCKET PIN HOLE

Loosen the two M3 set screws on the(Do Not Remove)

socket assembly rods that are located on the opposite side of

socket pin holes.

(L)

FIXTURE ROD

NOTE: To avoid interference while relamping do not

cut the fixture rods (LI) more than 24" inches.

Cut the fixture arms with a sharp cutter. (Optional)

1A1A

1A1B

1A1C

3 2

Monorail

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980MRLTUB3P Tube 3 HS2933FR_1B35MRL 1.2 Monorail GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product is intended to be used with LBL Monorail system. Connect the Fixture Arms 1A 1B 1A FIXTURE FUSION JACK (L) 3 2 (H1) FIXTURE ROD 2 Mark amount (LI) from one end of the fixture rod that needs to be cut shorter.
PAGE 2
1D 1A 5 FIXTURE FUSION JACK M3 SET SCREW 5 1.5 MM ALLEN WRENCH SOCKET ASSEMBLY ROD SOCKET PINHOLE 5 1G 1A FIXTURE ROD TOP SOCKET ASSEMBLY ROD Insert the two fixture rods on the opposite side of socket pin holes, completely into the socket assembly rod and secure into place by tightening the M3 set screws with the provided 1.5 MM Allen wrench. 8 (H2) 1A 1E 1.
PAGE 3
Install the Lamp 1A IJ 1A 2A 12 M3 SET SCREW 12 12 1.5 MM ALLEN WRENCH SOCKET 12 SOCKET PIN HOLE 1 1 12 Loosen (Do Not Remove) the four M3 set screws on the middle socket assembly rods. M3 SET SCREW 1A IK 1.5 MM ALLEN WRENCH NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. TOP FUSION JACK ASSEMBLY ROD 1 For each socket, loosen (Do Not Remove) the two M3 sets screw with the 1.5 MM Allen wrench.
PAGE 4
Install the Fixture to Monorail 3A 1A 1A 2C CAP 2 3 FUSION JACK ADAPTER 1 Unscrew the cap from the Fusion Jack adapter. 2 Select a place on the Monorail where the fixture is going to be mounted. 3 From the bottom, place the Fusion Jack adapter onto the Monorail. 4 Replace and tighten the cap to the Fusion Jack adapter. Make sure that the cap is not cross threaded.