Instruction Manual

2
Loosen the two M3 set screws on the(Do Not Remove)
sides of the Fusion Jack assembly rod with the provided
1.5 MM Allen Wrench.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FUSION JACK
ASSEMBLY ROD
Insert the fixture rods into the Fusion Jack assembly rod, make
sure the fixture rods are aligned with the top of the Fusion
Jack assembly rod.Tighten the two M3 set screw with 1.5 MM
Allen wrench.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FIXTURE ROD
FUSION
JACK
ASSEMBLY
ROD
M3 SET
SCREW
FIXTURE ROD
Insert the two fixture rods on the opposite side of socket pin
holes, completely into the socket assembly rod and secure into
place by tightening the M3 set screws with the provided
1.5 MM Allen wrench.
1.5 MM ALLEN
WRENCH
SOCKET
ASSEMBLY
ROD
(H2)
GLASS SHADE
FIXTURE
FUSION
JACK
The height (H2) is measured from bottom of the bottom glass
shade to the middle of the top socket assembly rods.
Determine the desired (H2) fixture height.The height (H2) is
39" inches when the fixture rods are not cut.
Insert the fixture rods into the top Fusion Jack assembly rods,
and tighten the two M3 set screw with 1.5 MM Allen wrench.
Mark amount (L2) from one end of the fixture rod that needs
to be cut shorter. (Optional)
(L2)
FIXTURE ROD
NOTE: To avoid interference while relamping do not
cut the fixture rods (L2) more than 24" inches.
10
Cut the fixture arms with a sharp cutter. (Optional)
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FIXTURE ROD
FUSION JACK
ASSEMBLY ROD
SOCKET
PINHOLE
TOP SOCKET
ASSEMBLY ROD
5
6
6
1A1D
1A1E
6
5 5
7
7
1A1F
7
8
9
1A1G
1A1H
11
1A1I
10
10 9
11
8