Instruction Manual

3
M3 SET
SCREW
1.5 MM
ALLEN
WRENCH
SOCKET PIN HOLE
Loosen the four M3 set screws on the(Do Not Remove)
middle socket assembly rods.
Insert the Fusion Jack assembly rods from the end opposing
the socket pin holes onto the fixture rods. Make sure that the
bottom Fusion Jack assembly rods are in line with the top
Fusion Jack assembly rods and tighten the two M3 set screws
with the 1.5 MM Allen wrench.
MIDDLE FUSION
JACK ASSEMBLY
ROD
FIXTURE ROD
Install the Lamp
For each socket, loosen the two M3 sets(Do Not Remove)
screw with the 1.5 MM Allen wrench.
1.5 MM ALLEN
WRENCH
M3 SET
SCREW
NOTE: Use only your fingers and soft cloth to replace
the lamp.
Use Watt,Type XelogenMAX 35
(Xenon) Bi-Pin Lamp,With Each Socket.
Push the lamp pins completely into the socket holes and
tighten the two M3 set screws with the 1.5 MM Allen wrench
to secure lamp in place.
WARNING: RISK OF FIRE
Never replace a Xenon (Xelogen) lamp with a regular
Halogen lamp.A regular Halogen lamp requires a protective
glass shield.
LAMP
NOTE: To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
3
TOP FUSION JACK
ASSEMBLY ROD
12
13
1AIJ
1AIK
1
2
1A2A
1A2B
12
12
12
12
13
13
2
2
SOCKET
1.5 MM ALLEN
WRENCH
M3 SET
SCREW
1
1